Annotation Commands

The Annotation commands are a set of commands which allow you to add comments, draw and communicate with others in your simulation.

Annotation commands are a great tool to work with whilst reviewing a product in SkyReal. They enable the user to quickly add notes, draw a sketch or add symbols to attract attention to a specific location in the simulation. Moreover, these commands can enhance and ease communication between users.

These commands are accessible from the default Tools sub menu:

all_v1.11_skyreal_vr_interface_tools_sub_menu

3D annotation

T_SplineAnnotation

When you activate this command, you will be holding a pen instead of your controller in VR. Simply press and hold the trigger, and you will be able to write and draw using this pen.

The created annotations will be visible to all of the users in the simulation.

3D symbol picker

T_CollectionPicker

Upon activating this command, a symbol picker will appear. This symbol picker has different categories of symbols, which you can go through by moving the navigation pad to the left or right. Each category contains different symbols which you can spawn into your simulation.

These symbols will be visible to all of the users in the simulation.

Spawn 3D arrow

T_Draw3DArrow

When you activate this command, you will be holding a pen instead of your controller in VR. Simply press and hold the trigger, and you will be able to write and draw using this pen.

The created arrows will be visible to all of the users in the simulation.

Clear annotations

T_Clean

When used, this command will delete ALL annotations, measures and symbols from your simulation.

If you wish to delete an annotation, symbol or measure individually, you must first select it, and then use the Delete command from the Appearance tab in the 2D Command Menu.

Issue reporting

T_TicketsEdit

This command is available only if your session is connected to XR Center. Reporting an issue with this command will create a ticket in XR Center.

Video Example

Custom Parameters

Command Parameters
3D symbol picker Num to display, Board X num, Board Y num, Angle offset, Angle offset board, Anim time, Infinite loop, Forbidden icons, Use original element size
Spawn 3D arrow Arrow line thickness, Arrow color, Is using collab color, Is dotted line, Direction pointed by arrow
3D annotation Writing line thickness, Writing delta between two points, Use collaborative color, Annotation color
Clean annotations -
Issue reporting -